Z Series E86 Z4 3.0Si (N52) COUPE
33 31 000
Removing and installing complete rear axle
carrier
Special tools required:
•
33 4 420
Necessary preliminary tasks:
•
Remove propeller shaft from rear differential and tie back
Important!
Risk of damage!
Brake hose must not be exposed to tensile loads.
Release bolt (1) and remove bracket with brake hose.
Tightening torque 34 32 3AZ
.
Release screw and remove cable clip (2).
Disconnect plug connection for right brake pad wear sensor on
brake caliper.
Remove brake caliper on both sides of trailing arm and tie back.
Remove both coil springs.
Remove lower control arm on both sides from trailing arm .
Slide brake caliper through between output shaft and
lower control arm and tie up.
RA Removing and installing complete rear axle carrier
BMW AG - TIS
08.02.2013 11:17
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
