Z Series E86 Z4 3.0Si (N52) COUPE
51 16 239
Removing and installing/replacing lid on rear
storage box
Necessary preliminary tasks:
•
If necessary, remove eject box from storage box lid
Open lid (1) and release screws (2) on bearing (3).
Note:
Wire (3) of dia. 1.9 mm and approx. 60 mm in length is
required.
Open lid (1) approx. 150 mm.
Slide wire (3) into bore (2) and release lid (1).
Important!
Risk of damage!
Lid (3) must neither be completely open nor opened further.
Wire (4) must remain in lid (2).
In this position, unclip lid (3) with bearings (2) in direction of
arrow out of mountings (1).
If necessary, disconnect plug connections from additional
equipment.
RA Removing and installing/replacing lid on rear storage box
BMW AG - TIS
08.02.2013 13:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -