Z Series E86 Z4 3.0Si (N52) COUPE
51 16 026
Replacing mirror glass
Warning!
If mirror glass is damaged:
Wear protective goggles and tearproof gloves during the
removal operation.
Risk of injury by flaking-off glass splinters.
Tilt mirror glass (1) downwards.
Tape off housing edge and mirror glass with adhesive tape (2)
(risk of damage).
Slide bore of bayonet lock (3) with a suitable tool to left until
bayonet lock (3) is fully unlocked.
Note:
Also slide bayonet lock (3) to left on right side.
Remove mirror glass from mirror and disconnect plug
connections (1) for mirror heating.
Disconnect plug connection (3) for automatic dimming action and
mirror glass (2).
Installation:
Clip plug connection (3) into holder (4).
Installation:
Following parts of mirror glass must not be damaged or missing:
1
Connections for mirror heating
2
Locating pin on bayonet lock
3
Guides for cable of automatic dimming action
Position mirror glass with locating pin (1) on mounts on servodrive.
Slide bayonet lock to right until bore (4) is vertical.
Check function.
RA Replacing mirror glass
BMW AG - TIS
08.02.2013 13:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -