Z Series E86 Z4 3.0Si (N52) COUPE
Release screws (1).
Remove housing cover (2) and PCB (3) underneath.
Remove switch unit (1) in upward direction.
Installation:
Switch unit (1) can only be installed in one position.
PCB (4) can be inserted turned through 180
°
.
Position of magnet sensor (3) of PCB (4) must match up with
permanent magnet (2) of switch unit (1).
Remove guide (1) in upward direction.
Installation:
Guide (1) can only be installed in one position.
Fit seal (2) on guide (1) and insert in switch housing.
Important!
Ignition key must be inserted in lock cylinder, otherwise this
will be destroyed when removed.
Insert ignition key in lock cylinder (2).
Carefully release catches (1) in outward direction and press out
lock cylinder (2) with ignition key.
Installation:
Lock cylinder (2) can only be inserted in "ON" or "OFF" switch
position.
Lock cylinder
RA Removing and installing/replacing lock cylinder for passenger airbag deactivatio
BMW AG - TIS
08.02.2013 14:06
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
