bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

1 RA Instructions On Gluing Windscreen|Page 1501 > < 6 RA Replacing Rubber Mount On Rear Lid Lid Support
Page 1
background image

51 31 ...

Instructions on gluing windscreen

Important!

The following topics were included or amended in October 2007:

 

Version with head-up display (HUD):

When replacing windscreen, replace rain/light solar sensor, see repair instruction .

 

These instructions are not applicable to door window cementing (door "centre") on the E38/L7:

Work steps for removing and installing windscreens:

is displayed at the end of this document by clicking on the "framed cross-reference"

General:

The windscreen and rear window (also the rear side windows if necessary) are bonded to the body. This gluing will

increase the torsional strength of the vehicle. To obtain perfect bonding, comply with the installation procedure
described in the following. 

It is possible to tow or drive without windscreen or rear window.

The windscreen must be secured with yellow plastic adhesive tape (sourcing reference: BMW Parts Service) after
being installed. The paint must be completely hardened after painting work.

Set down window glass and process on BMW-approved X-universal stand.

In winter, the vehicles must stand in a room with a temperature of at least 15 

°

C.

On-the-job safety:

When working with adhesive products (adhesive, cleaning agent, bonding agent etc.):

Wear protective goggles, protective gloves and if necessary an apron.

Ensure rooms are well ventilated.

Change work clothing contaminated with adhesive immediately.

Change work clothing contaminated with solvents and swelling agents immediately (keep spare work clothing on

hand).

Take skin protection measures, provide washing facilities including hot water, use silicone-free skin creams

Provide eye bath facilities, change water regularly (once a month).

Comply with the relevant safety regulations

Do not eat, drink or smoke in areas of PUR processing.

 

Replacement of windscreens:

Version with head-up display (HUD):

Marking for HUD must be present on the windscreen

Version with front passenger airbag:

Stick on reminder label

RA  Instructions on gluing windscreen

BMW AG - TIS

08.02.2013  14:20

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

1 RA Instructions On Gluing Windscreen|Page 1501 > < 6 RA Replacing Rubber Mount On Rear Lid Lid Support