Z Series E86 Z4 3.0Si (N52) COUPE
Note:
Sealing lip (1) of window cavity cover strip must not protrude over
door window glass (2).
Adjusting longitudinal direction:
Remove outside door handle.
Slacken screw (1) in clockwise direction slightly.
Slide door window glass (2) into desired position.
Note:
Clamping plate (3) must not be moved in the process.
Tighten down screw (1) in counterclockwise direction.
Tightening torque 51 32 2AZ
.
Check adjustment, repeat procedure if necessary.
Ideal adjustment, retraction depth:
-
Open front door
-
Attach special tool 51 3 080 to door window glass
-
Close front door and door window
-
Measure retraction depth; adjust if necessary
Note:
2 items of special tool 51 3 080 are required for rapid
adjustment of retraction depths.
Measure retraction depth (X) in areas (A to C).
Retraction depth (X):
A = 3
±
0.5 mm (25 mm behind seal, triangular mirror section)
B = 4
±
0.5 mm (end of glass radius)
C = 4
±
0.5 mm (vertically over front of door handle)
Important!
Front door must open and close without the door window
glass touching the roof trim strip.
RA Adjusting left or right front door window glass
BMW AG - TIS
08.02.2013 14:24
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -