Century L4-151 2.5L (1989)
1.
Apply RTV sealer GM P/N 12345739 or equivalent
2.
Oil pan to engine block
3.
Oil pan retaining bolts
Tighten Bolts to 10 N-m (89 lbs.in.)
4.
Remove jack stand and wood support
5.
Lower vehicle
6.
Fill engine oil. Refer to Maintenance and Lubrication (Section 0B).
7.
Nuts holding engine support bracket to engine mount and mount assembly to frame assembly, bracket and mount.
8.
Lower front of engine
9.
Raise vehicle
10.
Transaxle mounting nuts.
Tighten Nuts to 50 N-m (37 lbs.ft.).
11.
Engine support bracket bolts to engine
Tighten Bolts to 50 N-m (37 lbs.ft.)
12. Flywheel cover
13.
Starter assembly and support bracket. Refer to Cranking System (Section 6D2).
14.
Flywheel cover bolts
Tighten Bolts to 10 N-m (89 lbs.in.)
15.
Wire harness to bracket at transaxle
16.
Rear A/C compressor mounting bracket bolts
Tighten Bolts to 30 N-m (22 lbs.ft.)
17.
Lower front A/C compressor mounting bolts and support brace
Tighten Bolts to 25 N-m (18 lbs.ft.)
18.
Exhaust pipe and converter
19.
Right engine splash shield
20.
Right front tire and wheel assembly. Refer to Tires and Wheels (Section 3E).
21.
Lower vehicle
22.
Remove J 24867-A
23.
Upper front A/C compressor to mounting bracket bolts
Tighten Bolts to 25 N-m (18 lbs.ft.)
24.
Engine torque strut to engine bracket
Nuts to 56 N-m (41 lbs.ft.)
25.
Serpentine belt
26.
Air cleaner and duct assembly
Inspect
Oil level Leaks
