Century L4-151 2.5L (1989)
3.
Lower control arm ball joint in knuckle, refer to Front Suspension (Section 3C).
4.
Brake line bracket.
5.
Position stabilizer, install bolts, refer to Front Suspension (Section 3C).
6.
Reinforcement bolts.
7.
Lower ball joint pinch bolt, refer to Front Suspension (Section 3C).
8.
Drive axle washer and new nut tighten. Nut to 260 N-m (185 lb.ft.)
9.
Seat the drive axle into the transaxle by placing a screwdriver into the groove on the joint housing and tapping until seated.
10.
Verify that drive axle is seated in transaxle by grasping on the housing and pulling outboard, Do not grasp and pull on axle shaft.
11.
Tie rod end in knuckle, nut, and cotter key, refer to Front Suspension (Section 3C).
12.
Tire and wheel assembly, refer to Tires and Wheels (Section 3E).
13.
Lower vehicle.
