Century L4-2.2L VIN 4 (1994)
INSTALLATION
1.
Coat front cover seal contact area with engine oil.
2.
Apply RTV sealer No. 1052917 or equivalent, to keyway in pulley hub.
3.
Place crankshaft pulley hub into position over key on crankshaft.
4.
Install crankshaft pulley installer No. J 29113 into crankshaft so that at least 1/4 inch of thread is engaged.
5.
Pull pulley hub into position and remove tool from crankshaft.
6.
Install crankshaft pulley, then three pulley retaining bolts.
7.
Install inner slash shield, then wheel and tire assembly.
8.
Lower vehicle and install serpentine belt.
9.
Connect battery ground cable.
