Century L4-2.2L VIN 4 (1994)
EVAP Canister Purge Solenoid Wiring Circuit
Circuit Description:
Canister purge is controlled by a solenoid valve that allows manifold and/or ported vacuum to purge the canister when energized. The Powertrain
Control Module (PCM) supplies a ground to energize the valve (purge "ON"). The purge solenoid valve control by the PCM is pulse width modulated
(turned "ON" and "OFF" several times a second). The duty cycle (pulse width) is determined by "Closed Loop" feed back from the Oxygen Sensor
(O2S). The duty cycle is calculated by the PCM and the output commanded when the following conditions have been met:
^
Engine run time after start more than 65 seconds.
^
Engine coolant temperature above 56°C (133°F).
Chart Test Description: Number(s) below refer to circled number(s) on the diagnostic chart.
1.
Checks to see if the solenoid valve is opened or closed. The solenoid valve is normally deenergized in this step, so it should be closed.
2.
Checks to determine if solenoid valve was open due to electrical circuit problem or defective solenoid.
3.
Completes functional check by grounding test terminal. This should normally energize the solenoid valve opening the valve which should allow the
vacuum to drop (purge "ON").
Diagnostic Aids: Make a visual check of vacuum hose(s). Check throttle body for possible cracked, broken, or plugged vacuum block. Check engine for
possible mechanical problem.
