Century L4-2.2L VIN 4 (1994)
Installation
1.
Lubricate new injector O-ring seals with clean engine oil, and install on injector assembly.
^
See "CAUTION" statement above.
2.
Install bottom feed multiport injector assembly into lower manifold injector socket with electrical connectors facing inward.
3.
Install injector retainer bracket.
^
Carefully install bracket so that injector retaining slots and regulator are aligned with bracket slots.
4.
Reconnect injector electrical connectors.
5.
Install pressure regulator assembly.
^
Refer to "Fuel Pressure Regulator."
6.
Install injector retainer bracket attaching screws. Tighten injector retainer bracket attaching screws to 3.5 N-m (31 lb. in.).
7.
Install upper manifold assembly.
8.
Install accelerator cable bracket with attaching bolts/nuts. Tighten cable bracket nut to 25 N-m (18 lb.ft.). Tighten accelerator cable bracket bolts to
25 N-m (18 lb. ft.).
9.
Tighten fuel filler cap.
10. Reconnect negative battery cable.
Inspection
^
Turn ignition switch to the "ON" position for two seconds, then turn to the "OFF" position for ten seconds. Again turn to the "ON" position and
check for fuel leaks.
11. Install air intake duct.
