Century L4-2.2L VIN 4 (1994)
12.
Connect the inflator module to the pigtail adapter on the SIR Deployment Harness. The SIR Deployment Harness shall remain shorted and not be
connected to a power source until the air bag is to be deployed. The inflator module will immediately deploy the air bag when a power source is
connected to it. Refer to Figure 5.
Important:
Ensure that the pigtail adapter is firmly seated into the inflator module connector. Failure to fully seat the connectors may leave the shorting bar
located in the inflator module connector functioning (shorting the deployment circuit) and may result in nondeployment of the inflator module.
13.
Verify that the area around the inflator module is clear of all people and loose or flammable objects.
14.
Verify that the inflator module is firmly and properly secured in J 39401.
15.
Notify all people in the immediate area of your intention to deploy the inflator module. The deployment will be accompanied by a substantial noise
which may startle the uninformed.
16.
Separate the two banana plugs on the SIR Deployment Harness that were shorted together in Step 3. Refer to Figure 6.
NOTICE:
When air bag deploys, the rapid gas expansion will create a substantial noise. Notify all people in the immediate area that you intend to deploy the
inflator module.
CAUTION:
Deployment harness shall remain shorted and not be connected to a power source until the air bag is to be deployed. The inflator module will
immediately deploy the air bag when a power source is connected to it. Connecting the deployment harness to the power source should always be the
last step in the inflator module deployment procedure. Failure to follow procedures in the order listed may result in personal injury.
