Century L4-2.2L VIN 4 (1994)
Power Window Motor: Service and Repair
Regulator Tape
Tape Drive Regulator Service Parts - Electric Shown, Manual Similar
Tape Length For Window Regulators
Remove or Disconnect
1. Water deflector.
2. Raise window to full-up position and secure to door frame using masking tape.
3. Sash bolts.
4. Using regulator handle or motor (if electric), position sash to center of large access bole.
5. Insert thin, flat-bladed screwdriver into slot at top of guide. Press down on screwdriver and pull forward to disengage block from guide. Using
thumb, push up on guide to remove guide from block Remove block from tape and let guide and sash drop to bottom of door.
6. Tape from tabs using flat-bladed screwdriver.
7. Use crank handle or run regulator motor (if electric) to remove tape from regulator.
Install or Connect