Century V6-173 2.8L (1986)
Piston: Recalls
Procedure to Install New Engine:
1.
Install lift device.
2.
Dismount engine from stand.
3 .
Install flexplate.
4.
Install engine in car.
5.
Install bellhousing bolts.
6.
Connect grounds and harness bracket at bell housing studs.
7.
Connect strut bracket at radiator support.
8.
Raise vehicle.
9.
Connect wires at engine (bottom).
10.
Install mount nuts.
11.
Connect transmission bracket at engine.
12.
Install crank pulley.
13.
Install flexplate to torque converter bolts.
14.
Connect exhaust pipe at manifold.
15.
Connect lower radiator hose.
16.
Connect fuel lines at fuel pump.
17.
Install lower A/C adjusting bracket.
18.
Install starter.
19.
Connect wires at starter.
20.
Install flywheel cover.
21.
Install inner fender splash shield.
22.
Lower vehicle.
23.
Connect lines at transmission.
24.
Connect transmission dipstick tube at manifold.
25.
Connect wire harness at rear of right hand head.
26.
Connect AIR hose at Catalytic Converter AIR pipe.
27.
Connect A/C compressor to brackets.
28.
Connect wires at A/C compressor and pressure cutoff switch.
29.
Connect power steering pump at engine.
30.
Install power steering belt and adjust.
36.
Install thermostat housing stud (to attach crossover).
37.
Connect necessary wires at engine (top).
38.
Connect necessary vacuum hoses.
