Century V6-173 2.8L VIN W FI (1987)
Crankshaft Position Sensor: Service and Repair
Typical DIS Crankshaft Sensor
REMOVAL
^
Disconnect Sensor harness connector.
^
Remove sensor to block bolt.
^
Remove sensor from engine.
^
Remove sensor O-ring.
^
Discard O-ring.
INSTALLATION
^
Install new O-ring on sensor, lube new O-Ring with engine oil before installing.
^
Install sensor into hole in block.
^
Install sensor to block bolt.
^
Torque to 8 Nm (71 lb in).
^
Reconnect sensor harness connector.
