Century V6-173 2.8L VIN W FI (1987)
Transmission Cooler: All Technical Service Bulletins
Preparation
1.
After overhauled or service replacement, transmission/transaxle is reinstalled in vehicle; do not reconnect oil cooler pipes.
2.
Remove fill cap on tool and fill can with 0.6 liter (20-21 ounces) of Kent-Moore biodegradable flushing solution. Do not overfill or tool will need
to be recharged with air before back flush. Follow manufacturer's suggested procedures for proper handling of solution.
IMPORTANT:
Do not substitute with any other solution. The flushing tool is designed to use only this concentrate. Use of any other solution can result
in damage to the tool, cooler components, or improper flushing of the cooler.
3.
Secure fill cap and pressurize the flusher can with shop air to 550-700 KPA (120 PSI).
CAUTION: Shop air supply must be equipped with a water/oil filter and not exceed 825 KPA (120 PSI).
4.
Connect the discharge hose to the transmission end of the oil cooler pipe that goes to the top fitting at the radiator.
5.
Clip discharge hose onto the oil drain container.
6.
Mount the flushing tool to the undercarriage of vehicle with the hook provided and connect the hose from the flushing tool to the remaining oil
cooler pipe.
7.
With the water valve on the tool in the off position, connect the water hose from the water supply to the tool.
8.
Turn on the water supply at the faucet.
