Century V6-181 3.0L (1983)
FIGURE 2 - BRAKE PROPORTIONER INSTALLATION
3.
Refer to Figure 2 for valve replacement procedure..
4.
Bleed master cylinder and proportioner valve connections as follows:
a.
If the car is equipped with power brakes, remove the vacuum reserve by applying the brakes several times.
b.
After installing new valve(s), reconnect all removed brake pipe connectors.
c.
Fill the master cylinder reservoirs with brake fluid and keep at least one-half full of fluid during the bleeding operation.
d.
Remove left front pipe connector. Refer to Figure 3. When brake fluid begins to flow from left front master cylinder port, reconnect left
front brake pipe and tighten to specified torque.
e.
Slowly apply brake pedal until firm.
f.
Loosen left front brake pipe connector to purge air. Retighten connector and slowly release brake pedal. Wait 15 seconds.
9.
Repeat (e) and (f) until all air is purged. IMPORTANT:
COMPLETE (g) BEFORE ATTEMPTING (h) AND (i).
