Century V6-181 3.0L (1983)
FIGURE 6 - JUMPER HARNESS TO ENGINE HARNESS CONNECTIONS
12.
Install the four wire terminals removed in Step 10 into the three furnished connectors as shown, and plug the connectors into the jumper harness.
Refer to Figure 6. Original wire colors must match the wire colors in the jumper harness, except for the wire remove from cavity "C" of original
connector on vehicles with heater and heavy-duty cooling. Refer to important note on Figure 6.
13.
Check cooling fan high-speed relay operation by grounding the relay jumper harness dark green with yellow striped wire. Any change from the
following procedure could result in damage to the new relay.
a.
Insert a jumper wire probe in relay jumper harness connector cavity "B" so that probe contacts terminal of the dark green with yellow
striped wire. Refer to Figure 6.
b.
Attach the other end of jumper wire to a suitable ground (sheet metal screw, battery negative terminal, etc).
c.
Remove tape from battery positive terminal and reinstall positive cable.
d.
Recheck to be sure you have a good connection between ground and jumper harness dark green wire with yellow stripe.
e.
Place air conditioner selector lever in the "OFF" position.
f.
Turn ignition switch to "ON". Fan should run at high speed. If fan does not operate, cause should be determined and corrected.
9.
Allow fan to operate for a minimum of ten (10) seconds. Turn ignition off and remove jumper wire.
14.
Reinstall left sheet metal brace front attaching screws and tighten the rear attaching screw. Be sure plastic conduit is on brace in area over battery.
15.
Install campaign identification label as instructed in Part III, Page 8.
