Century V6-181 3.0L (1983)
FIGURE 3 - INSTALLATION OF RELAY
8.
Reinstall plastic protector on tie bar, plug jumper harness connector on relay and attach relay to tie bar using furnished screws. Refer to Figure 3.
FIGURE 4 - REMOVING HIGH SPEED FAN RELAY
9.
Remove the fuel pump, high and low-speed relay mounting bracket, from left wheel house. Remove the fan high-speed (center) relay from bracket.
Refer to Figure 4.
IF VEHICLE IS EQUIPPED WITH HEATER AND HEAVY DUTY COOLING, PRIOR TO THE FOLLOWING STEP, INSTALL FAN
SINGLE/LOW-SPEED RELAY AS INSTRUCTED IN STEPS 3, 4, AND 5 OF PART II OF TECHNICAL PROCEDURE.
