Century V6-204 3.3L VIN N FI (1990)
Exhaust Manifold (Right Rear)
Figures 1 and 2
Remove or Disconnect
1.
Negative battery cable. Air cleaner and duct assembly.
3.
Serpentine belt.
4.
Drain coolant.
5.
Power steering pump brace, and bolts from mounting bracket, set pump forward.
6.
Spark plugs wire loom, wire harness, set aside.
7.
Oxygen sensor wire connector.
8.
Engine lift bracket nuts from exhaust manifold.
9.
Coolant tube, engine lift bracket and fuel line clamp screw from coolant tube assembly, move aside.
10.
Right bank of spark plugs.
11.
Exhaust crossover tube.
12.
Transaxle fill tube retaining bolt, move tube for access.
13.
Raise vehicle and suitably support. Refer to General Information (Section 0A).
14.
Exhaust pipe from manifold.
15.
Lower vehicle.
16.
Exhaust heat shield retaining nuts, pull shield back.
17.
Manifold studs and manifold.
18.
Exhaust heat shield.
Install or Connect
1.
Manifold, studs and heat shield.
Tighten Studs to 52 N-m (38 lbs.ft.).
2.
Exhaust heat shield retaining nuts.
Tighten Nuts to 26 N-m (18 lbs.ft.).
3.
Raise vehicle and suitably support. Refer to General Information (Section 0A).
4.
Exhaust pipe to manifold.
