Century V6-204 3.3L VIN N FI (1990)
The balancer is serviced as an assembly. Do not attempt to separate pulley from balancer hub.
Install or Connect
1.
Crankshaft balancer
^
Lubricate seal surface with engine oil
2.
Balancer bolt and washer
^
Hold flywheel with tool J-37096
^
Balancer bolt to 140 N-m (103 lbs.ft.)
-
Loosen bolt to finger tight
-
Utilizing tool J-36660, retorque to 150 N-m (110 lbs.ft.)
plus 56 degrees
3.
Inner fender splash shield
4.
Right front wheel and tire assembly
5.
Torque converter cover
6.
Lower car
7.
Serpentine belt
8.
Negative battery cable
Note:
After installation of either of the hose assemblies and/or pump, it is essential that the system be properly bled following the procedure in the 1992
Service Manual.
WARRANTY INFORMATION:
Labor Operation Number:
T1743
Labor Time:
Step "A"
- 1.2 Hours
Steps "A and B"
- 1.3 Hours
Steps "A and C"
- 1.6 Hours
Steps "A, B and C"
- 1.7 Hours
Steps "A, C and D"
- 2.0 Hours
Steps "A, B, C, and D"
- 2.1 Hours