Century V6-204 3.3L VIN N FI (1990)
PROM - Programmable Read Only Memory: Customer Interest
Procedure:
Where necessary use the specified torque requirements as shown in the appropriate Service Manual.
1.
Disconnect the negative battery cable.
2.
Discharge and recover the A/C system.
3.
Remove the grille.
4.
Remove the A/C condenser and the center front end support following the appropriate Service Manual procedures.
5.
Discard the old upper and lower condenser insulators, refer to Figure 1.
6.
Install the new condenser, as shown in Figure 1, using Service Manual procedures.
7.
Install the front end center support.
8.
Clean the top surface of the blower motor and install the new A/C charge specification Label.
9.
Evacuate, charge and leak test the A/C system. Note new charge specifications.
