Century V6-204 3.3L VIN N FI (1990)
INSTALL OR CONNECT
1. Using J 29022-A, rivet regulator to inner panel using 1/4 inch x 1/2 inch aluminum peel type rivets (part no. 9436175 or equivalent). If rivet tool
is not available, use the following nuts and bolts method.
2. U clips on regulator at three attaching locations. Be sure to install clips with clinch nuts on outboard side of retainers.
3. Slide regulator through the rear access hole and align regulator attaching clips with holes in inner panel. Attach regulator metal retainers with M6.0
x 1 x 13 (1/4-20 x 1/2 inch) screws (part no. 9419723 or equivalent). Attach housing part of regulator with M6.0 x 1 x 13 (1/4-20 x 1/2 inch)
screws into 6 mm (1/4 inch) nuts with integral washers.
TIGHTEN
^
Screws to 12 Nm (106 lb. in.).
4. Lower sash bolts.
5. Water deflector and door trim panel.
6. Tape from window.
