Century V6-204 3.3L VIN N FI (1990)
Power Window Motor: Service and Repair
Trim Panels
TRIM PANELS
Trim Panel Removal & Installation
Courtesy Lamp Assembly
TOOL REQUIRED:
^
J 24595-B Door Trim Pad and Garnish Remover
^
The one-piece trim panel hangs over the door inner panel across the top and is secured by retainers down the sides and two clips at the split line. It
is retained by screws located in the areas of the top front of panel assembly and armrest.
REMOVE OR DISCONNECT
1. All door inside handles.
2. Door inside locking rod knob.
3. Screws inserted through door armrest into door inner panel or armrest hanger support brackets.
4. On styles with remote control mirror assemblies, remove remote mirror escutcheon and disengage end of mirror control cable from escutcheon.
5. On styles with power window controls located in door trim assembly, disconnect wire harness at switch assembly.
6. Remove control handle escutcheon screws.
7. Screws, plastic retainers and clips from perimeter of door trim pad using J 24595-B and a screwdriver.
8. Escutcheon from trim panel.
