Century V6-204 3.3L VIN N FI (1990)
Rear Door Hardware
TOOL REQUIRED:
^
J 29022-A Hand Riveter
REMOVE OR DISCONNECT
1. Door trim panel and water deflector.
2. Tape window to frame in up position using cloth-backed tape.
3. Lower sash bolts and sash by rotating 90 degrees and pulling outboard.
4. Punch out center pins of regulator rivets. Drill out rivets using 1/4 inch drill bit.
5. For manual regulator, remove regulator through largest access hole. For electric regulator, remove window. Move regulator and motor assembly
rearward and remove electrical connector. Remove regulator and motor assembly through largest access hole.
