Century V6-204 3.3L VIN N FI (1990)
Window Handle: Service and Repair
INSIDE HANDLES AND SWITCH PLATE
Typical Window Regulator Handle Installation
TOOL REQUIRED:
^
J 9886-01 Door Handle Clip Remover
^
Door inside handles are retained by either rivets or spring clips. On styles equipped with rivet retained handles, the rivets are covered by a screw
retained remote control escutcheon.
REMOVE OR DISCONNECT
1. Depress door trim assembly and insert J9886-01 between handle and trim panel or plastic bearing plate.
2. Push J 9886-01 to disengage clip.
3. Pull handle inboard to remove from spindle.
INSTALL OR CONNECT
1. Retaining clip on handle.
2. Position handle on spindle.
3. Press handle outboard until clip engages regulator spindle.
