Century V6-3.1L VIN J (2005)
Rear Door Panel: Service and Repair
Panel Replacement
Trim Panel Replacement - Side Rear Door
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Remove the power window switch (3), if equipped. Refer toPower Window Switch Replacement - Rear Door (See: Sensors and Switches/Sensors
and Switches - Windows and Glass/Power Window Switch/Service and Repair/Power Window Switch Replacement - Rear Door) .
2. Remove the arm rest pull cup cover (1).
3. Remove the armrest pull cup screws.
4. Starting at the door bottom, use theJ 38778 to release the door trim panel retainers.
5. Lift the trim panel up to release the top edge and remove it from the door.
Installation Procedure
Important: Before installing the door trim panel to the door, discard the old trim panel retainers. Use new trim panel retainers in order
to properly secure the trim panel to the door .
1. Install the new trim panel retainers to the trim panel.
2. Position the top of the trim panel at the window opening and press down.
3. Align the fasteners into the holes in the door metal.
4. Firmly press the door panel to seat the fasteners.
Notice: Refer toFastener Notice in Cautions and Notices.
5. Install the armrest pull cup screws.
Tighten the armrest pull cup screws to 2 Nm (18 lb in).
