Century V6-3.1L VIN J (2005)
2. If the location of the nameplate has not been marked, apply tape and use the following dimensions for the Buick door nameplate.
*
Dimension (A) 30 mm (1.188 in) from the top of the molding to the bottom of the nameplate.
*
Dimension (B) 80 mm (3.156 in) from the front edge of the door to the beginning of the nameplate.
3. If the location of the nameplate has not been marked, apply tape and use the following dimensions for the Regal door nameplate.
*
Dimension (A) 30 mm (1.188 in) from the top of the molding to the bottom of the nameplate.
*
Dimension (B) 80 mm (3.156 in) from the front edge of the door to the beginning of the nameplate.
4. For the CENTURY LIMITED nameplate apply to the recessed area in the door molding as shown.
5. Heat the mounting surface to approximately 27-41°C (80-105°F) using theJ 25070 , if necessary.
6. Ensure that the temperature of the nameplate is approximately 29-32°C (85-90°F).
Important: Do not touch the adhesive backing on the nameplate.
7. Remove the protective liner from the back of the nameplate.
8. Position the nameplate to the location marks and press the nameplate to the mounting surface.
9. Apply equal pressure along the nameplate to uniformly bond the item to the mounting surface.
10. Remove the protective tape from the mounting surface.
