Century V6-3.1L VIN J (2005)
Body Emblem: Service and Repair
Emblem/Nameplate Repair
Emblem/Nameplate Replacement - Door
Tools Required
J 25070 Heat Gun
Removal Procedure
1. When replacing or repairing a nameplate do the following:
1. Use tape to protect the mounting surface during removal.
2. Use tape for alignment marks for installation of the nameplate.
2. Heat the nameplate using theJ 25070 . Apply heat using a circular motion for about 30 seconds.
Notice: Refer toExterior Trim Emblem Removal Notice in Cautions and Notices.
3. Use a plastic, flat-bladed tool to remove the nameplate from the panel surface.
4. When replacing a nameplate, remove all adhesive as follows:
*
For body panels use a 3M(TM) Scotch Brite molding adhesive remover disk 3M(TM) P/N 07502 or equivalent.
*
For plastic panels use a lint-free cloth and Varnish Makers and Painters (VMP) naphtha or a 50/50 mixture by volume of isopropyl alcohol and
water to remove the adhesive.
Installation Procedure
Important: Apply the nameplate in an environment that is free from dust or other dirt that could come into contact with the sticky
backing. Foreign material may cause improper adhesion.
1. Ensure the area where the nameplate will be installed is clean and dry.