Century V6-3.1L VIN J (2005)
1. Insert the end of the replacement cable (3,4) into the drive screw.
2. Bend the cable and insert the other end into the motor.
3. If required, repeat the above procedure for the second drive cable.
Important: Examine all 4 drive cables to ensure that the cables are straight.
4. Connect the electrical connector to the seat wire harness and test the seat for proper operation.
5. Tip the seat forward and engage the seat hook attachments to the floor pan.
Notice: Refer toFastener Notice in Cautions and Notices.
6. Install the bolts that secure the adjuster to the floor pan.
Tighten the bolts to 42 Nm (31 lb ft).
7. Enable the SIR system. Refer toSIR Disabling and Enabling Zone 3 in SIR.
