Century V6-3.1L VIN J (2005)
6. Use the J 39505 in order to install the right oil pan side bolts.
^
Tighten the bolts to 50 Nm (37 ft. lbs.).
7. Use the jackstands to raise the frame to the original position
8. Install the right side frame bolts and tighten the left side frame bolts.
9. Remove the jackstands from the frame assembly.
10. Install the right lower ball joint to the steering knuckle.
11. Install the right outer tie rod to the steering knuckle.
12. Install the engine mount bracket with the engine mount to the oil pan.
13. Install the steering shaft intermediate pinch bolt.
14. Lower the vehicle.
15. Use the engine support fixture to lower the engine.
16. Raise and the vehicle.
17. Install the transaxle mount lower nuts.
18. Install the engine mount lower nuts.
19. Install the transaxle brace to the oil pan.
20. Install the starter motor.
21. Connect the oil level sensor electrical connector.
22. Install the 3-way catalytic converter pipe to the right exhaust manifold.
23. Install the A/C compressor.
24. Lower the vehicle.
25. Remove the engine support fixture.
26. Install the left and the right engine mount struts.
27. Install the drive belt.
28. Fill the engine with new engine oil.
