Century V6-3.1L VIN J (2005)
Control Assembly: Service and Repair
HVAC System - Automatic
HVAC CONTROL MODULE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the instrument panel trim plate.
2. Remove the HVAC control module mounting screws.
3. Disconnect the electrical connector.
4. Remove the HVAC control module.
INSTALLATION PROCEDURE
1. Connect the electrical connectors.
IMPORTANT: The key should be in the off position when connecting the electrical connectors to ensure proper calibration.
2. Install the HVAC control module.
3. Install the HVAC control module mounting screws.
Tighten the screws to 2 N.m (18 lb in).