Century V6-3.1L VIN J (2005)
Control Module HVAC: Service and Repair
BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the right side IP insulator Panel.
2. Disconnect the electrical connector from the blower motor control processor.
3. Disconnect the blower motor control processor electrical connector from the blower motor.
4. Loosen both of the forward bolts.
IMPORTANT: The opening to the blower motor control processor is slotted. Access to the blower motor control processor opening is limited.
5. Remove the rearward bolt.
6. Remove the blower control processor.
IMPORTANT: Tilt down the rear of the blower motor control processor.
INSTALLATION PROCEDURE
1. Install the blower motor control processor.
