Century V6-3.1L VIN J (2005)
Body Control Module: Scan Tool Testing and Procedures
Scan Tool Data Definitions
SCAN TOOL DATA DEFINITIONS
Software Part Number: Part number of component program or the ECU. Used to determine applicability to vehicle RPO content.
Accessory 1: Input from ignition switch ACCESSORY circuit. Used to determine power mode. Hot in ACCESSORY and RUN.
Battery Power 2: Input showing the state of the Battery Power 2 circuit to the control module.
Battery Power 3: Input showing the state of the Battery Power 3 circuit to the control module.
Battery Voltage: The scan tool displays 0.0-16.0 volts. The battery voltage input represents the system voltage measured at the BCM ignition feed
input.
Courtesy Ground: Input showing the state of the courtesy ground from the control module.
Crank: Input from ignition switch closed to B+ when the ignition switch is in the CRANK position.
Door Jamb Switch: Input showing state of the passenger doors.
Driver Door Switch: Input from the driver door indicating door status.
Ground 2: Input showing the state of the Ground 2 circuit to the control module.
Ignition 0: Input to the control module from the ignition switch indicating the Ignition 0 position. Switch closed (HOT) in ignition switch positions
Unlock, Accessory, Run, Crank
Ignition 1: Input to the control module from the ignition switch indicating the Ignition 1 position. Switch closed (HOT) in ignition switch positions Run,
Crank
Key In Ignition: Input from ignition switch indicating that the ignition key is inserted into the ignition switch. HOT with key in ignition and ignition
switch position LOCK.
RAP Output: Output indicates state that the control module has commanded.
Trunk Ajar Switch: Indicates state of switch used to control lamp in trunk and IPC indicator.