Century V6-3.1L VIN J (2005)
9. Disconnect the quick-connect fittings at the fuel sender assembly.
10. Hold down the fuel sender and remove the fuel sender retaining ring.
IMPORTANT: The retaining fuel sender assembly will spring-up when the ring is removed.
11. Remove the fuel sender assembly.
12. Clean the fuel sender assembly sealing surfaces.
13. Inspect the fuel sender assembly sealing surfaces.
INSTALLATION PROCEDURE
IMPORTANT:
-
Care should be taken not to fold over or twist the fuel pump strainer when installing the fuel sender assembly, as this will restrict fuel flow. Also,
assure that the fuel pump strainer does not block full travel of float arm.
-
Ensure that the fuel sender assembly retaining ring is fully seated within the tab slots on the fuel tank.
1. Position the new fuel sender assembly seal on the fuel tank.
IMPORTANT: Always replace the fuel sender seal when reinstalling the fuel sender assembly.
2. Place the fuel sender assembly into the fuel tank.
3. Install the fuel sender assembly retaining ring.
4. Connect the fuel sender electrical connector.
5. Install the fuel tank pressure sensor.
6. Connect the fuel tank pressure sensor electrical connector.
7. Connect the quick-connect fittings at the fuel sender assembly.
8. Connect the negative battery cable.
9. Inspect the fuel system for leaks by performing the following steps:
1. Turn ON the ignition for 2 seconds.
2. Turn OFF the ignition for 10 seconds.
3. Turn ON the ignition.
