Century V6-3.1L VIN J (2005)
Power Window Switch: Service and Repair
Power Window Switch Replacement - Rear Door
Power Window Switch Replacement - Rear Door
Removal Procedure
Important: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the
possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
Notice: Apply protective coating/tape at the insertion point of the small flat-bladed tool in order to prevent damage to the inner door trim panel.
1. Insert a plastic, flat-bladed tool at the front edge of the switch mounting plate. Press rearward to release the mounting plate retainer and lift up on
the front of the plate.
2. Lift the mounting plate and switch from the trim panel.
3. Disconnect the electrical connector from the power window switch.
4. Remove the switch from the mounting plate.
Installation Procedure
1. Install the switch tabs into the mounting plate.
2. Press down on the tabs in order to secure the switch.
3. Connect the electrical connector to the window switch.
