Century V6-3.1L VIN J (2005)
14. Unclip and remove the battery cable harness from the retainers.
15. Remove the battery cable harness from the vehicle.
16. Remove the negative battery cable from the wiring harness conduit.
INSTALLATION PROCEDURE
1. Install the negative battery cable into the wiring harness conduit.
2. Install the battery cable harness to the vehicle.
3. Install the battery cable harness to the retainers.
4. Install the ground cable to the transaxle stud.
5. Install the transaxle stud nut.
Tighten the nut to 30 N.m (22 lb ft).
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the positive battery cable to the starter motor BAT terminal.
7. Install the starter solenoid BAT terminal nut.
Tighten the nut to 9.5 N.m (84 lb in).
8. Install the front lower air deflector.
9. Install the positive battery cable harness to the BEC.
10. Install the BEC to the strut tower.
