Century V6-3.1L VIN J (2005)
14. Install the engine splash shield.
15. Install the wheel speed sensor harness (1) to the 4 retainers (2) at the frame.
16. Install the left front tire and wheel assembly.
17. Lower the vehicle.
18. Connect the transaxle wiring harness connector (2).
19. Install the wire harness (3) to the wire harness retainer (1).
20. Install the transaxle top side cover bolt.
21. Connect the range selector cable to the cable bracket and range selector.
22. Remove the engine support fixture.
23. Install the engine mount struts.
24. Install the throttle body air inlet duct.
25. Notice: Refer to Transmission Overfill Notice in Service Precautions.
Inspect the fluid level and fill the transaxle as necessary.
26. Inspect for fluid leaks.