Century V6-3.1L VIN J (2005)
Rear Door Window Motor: Service and Repair
Window Regulator Motor Replacement - Rear Door
Removal Procedure
1. Remove the rear door water deflector. Refer toWater Deflector Replacement - Rear Door (See: Body and Frame/Doors, Hood and
Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair) .
Important: The window regulator screws are seated into key slots in the inner door panel and is unnessessary to remove thescrews
completely from the window regulator.
2. Loosen the 3 rear door window regulator screws.
3. Position the rear door window regulator motor through the access opening in the inner door to gain access to the electrical connector and the rear
window regulator motor screws.
4. Disconnect the rear door window regulator motor electrical connector.
5. Remove the rear door window regulator motor screws.
6. Remove the rear door window regulator motor and bracket from the rear window regulator.
Installation Procedure
1. Position the rear door window regulator motor and bracket to the rear door window regulator.
Notice: Refer toFastener Notice in Cautions and Notices.
2. Install the rear door window regulator motor screws.
Tighten the screws to 6 Nm (53 lb in).
3. Connect the rear door window regulator motor electrical connector.
4. Position the rear door window regulator motor inside the rear door and install it into the key slots in the inner door panel.
5. Hand tighten the rear door window regulator screws.
Tighten the screws to 10 Nm (89 lb in).
6. Install the rear door water deflector. Refer toWater Deflector Replacement - Rear Door (See: Body and Frame/Doors, Hood and
Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair) .
