Century V6-3.1L VIN J (2005)
Rear Door Window Regulator: Service and Repair
Window Regulator Replacement - Rear Door
Removal Procedure
1. Remove the rear door water deflector. Refer toWater Deflector Replacement - Rear Door (See: Body and Frame/Doors, Hood and
Trunk/Doors/Rear Door/Rear Door Panel/Service and Repair) .
2. Remove the rear door window. Refer toWindow Replacement - Front Door (See: Window Glass/Front Door Window Glass/Service and Repair) .
3. Remove the rear door window regulator rail lower mounting screws.
Important: The window regulator screws are seated into key slots in the inner door panel and is unnessessary to remove thescrews
completely from the window regulator.
Loosen the rear door window regulator mounting screws.
4. Lower the rear door window regulator motor into the rear door to gain access to the electrical connector.
5. Disconnect the rear door window regulator motor electrical connector.
6. Remove the rear door window regulator from the rear door.
Installation Procedure
1. Position the rear door window regulator into the rear door.
2. Connect the rear door window regulator motor electrical connector.
3. Position the rear door window regulator motor inside the rear door and install it into the key slots in the inner door panel.
4. Position the rear door window regulator rail assembly inside the rear door and install it into the key slots in the inner door panel.
