Century V6-3100 3.1L VIN M SFI (1998)
Hydraulic Assembly: Service and Repair
ABS Motor Pack Replacement
REMOVAL PROCEDURE
1. Remove the gear cover (3).
IMPORTANT: Use care when handling the motor pack to avoid damaging the motor pack connector. Make sure brake fluid does not accidentally
intrude into the motor pack. Brake fluid in the motor pack may cause a premature failure of the motor pack.
IMPORTANT: Use care when handling the motor packs. Replace the motor packs if the motor packs are dropped or damages during handling.
2. Remove the four Torx head screws (5) that attach the motor pack (1).
3. Remove the motor pack assembly (1).
IMPORTANT: If the disassembly of the modulator/master cylinder assembly was caused by an ABS hydraulic functional test that did not pass,
the Automated ABS brake motor pack Diagnosis Test should be performed. Refer to Scan Tool diagnostics in Antilock Brakes. The Automated
ABS brake motor pack Diagnosis Test isolates the motor pack or brake modulator.
No repair of the motor pack is authorized. Replace as an assembly.
INSTALLATION PROCEDURE
1. With either of the modulators positioned upside down, rotate each ABS brake modulator gear counterclockwise until movement stops.
The above procedure will cause the following conditions:
^
The pistons on the ABS brake modulator will be positioned very close to the top of the modulator bore.
