Century V6-3100 3.1L VIN M SFI (1998)
5. Prime the ABS brake modulator/master cylinder assembly.
5.1. Attach the bleeder hose (3) to the rearward bleeder valve.
5.2. Submerge the opposite hose end in a clean container (3) partially filled with clean brake fluid.
5.3. Slowly open the rearward bleeder valve.
5.4. Depress the brake pedal and hold the pedal until the fluid begins to flow.
5.5. Close the valve and release the brake pedal.
IMPORTANT: Once the fluid is visibly flowing from both modulator bleeder valves, the ABS brake modulator/master cylinder assembly is
sufficiently full of fluid. However, it may not be completely purged of air. At this point, move to the wheel brakes and bleed the brakes. This
ensures that the lowest points in the system are completely free of air. Then purge the ABS brake modulator/master cylinder assembly of any
remaining air.
5.6. Repeat the previous three steps until air bubbles are no longer present.
5.7. Relocate the bleeder hose to the forward brake modulator bleeder valve.
5.8. Submerge the opposite hose end in a clean container (3) partially filled with clean brake fluid.
5.9. Slowly open the forward bleeder valve.
5.10. Depress the brake pedal and hold the pedal until the fluid begins to flow.
5.11. Close the valve and release the brake pedal.
5.12. Repeat the previous three steps until air bubbles are no longer present.
^
Tighten the ABS brake modulator bleeder valves to 9 Nm (80 inch lbs).
