Century V6-3100 3.1L VIN M SFI (1998)
10. Remove the brake fluid reservoir cover.
11. Inspect the brake fluid level in the reservoir. Fill the reservoir to the correct level if necessary.
12. Install the brake fluid reservoir cover.
13. Raise and suitably support the vehicle.
14. Use the following bleed sequence to bleed the system.
^
Right rear
^
Left front
^
Left rear
^
Right front
15. Perform the following steps in order to bleed the brakes in the sequence shown above:
15.1. Attach a clear bleeder hose (3) to the bleeder valve at the wheel.
15.2. Submerge the opposite hose in a clean container (2) partially filled with clean brake fluid.
15.3. Open the bleeder valve.
15.4. Slowly depress the brake pedal.
15.5. Close the valve and slowly release the brake pedal.
IMPORTANT: Once the fluid is visibly flowing from both bleeder valves, the traction control module is sufficiently full of fluid. However, it
may not be completely purged of air. At this point, bleed the wheels brakes. Bleeding the wheel brakes ensures that the lowest points in the system
are completely free of air. Then, purge the traction control module of any remaining air.
IMPORTANT: In order to assist in freeing the entrapped air, tap lightly on the caliper (1) or braking plate in order to dislodge any trapped air
bubbles.
15.6. Wait five seconds.
16. Repeat the following steps until the brake pedal feels firm at half travel and no air bubbles are observed in the bleeder hose:
16.1.
Remove the traction control module bracket bolt in order to access the bleeder valves.
