Century V6-3100 3.1L VIN M SFI (1998)
1. With either of the modulators positioned upside down, rotate each TCS modulator gear clockwise until movement stops.
The above procedure will cause the following conditions:
^
The pistons on the TCS modulator will be positioned very close to the bottom of the modulator bore.
^
The brake bleeding procedure becomes simplified.
IMPORTANT: Use care when handling the motor packs. Replace the motor packs if the motor packs are dropped or damaged during handling.
Align each of the three motor pack pinions (two are on the TCS) with the modulator gears.
2. Install the motor pack (1) to the modulator assembly (6).
3. Install four Torx head screws (4).
^
Tighten the Torx head screws to 4.5 Nm (40 inch lbs).
NOTICE: Refer to Fastener Notice in Service Precautions.
4. Install the gear cover (3) onto the modulator/brake master cylinder assembly.
