Century V6-3100 3.1L VIN M SFI (1998)
1. Install the exhaust crossover pipe.
2. Install the exhaust crossover pipe bolts.
^
Tighten the exhaust crossover pipe bolts to 25 Nm (18 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the exhaust crossover heat shield.
4. Install the exhaust crossover pipe heat shield bolts.
^
Tighten the exhaust crossover pipe heat shield bolts to 10 Nm (89 inch lbs.).
5. Install the vacuum modulator pipe.
6. Install the throttle body air inlet duct.
7. Connect the battery ground (negative) cable.