Century V6-3100 3.1L VIN M SFI (1998)
1. Install the left (front) exhaust manifold gasket.
2. Install the left (front) exhaust manifold.
3. Install the left (front) exhaust manifold nuts.
^
Tighten the left (front) exhaust manifold nuts to 16 Nm (12 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the left (front) exhaust manifold heat shield.
5. Install the left (front) exhaust manifold heat shield bolts.
^
Tighten the left (front) exhaust manifold heat shield bolts to 10 Nm (89 inch lbs.).
6. Install the exhaust crossover pipe heat.
7. Install the right engine mount strut bracket.
8. Install the throttle body air inlet duct.
9. Connect the battery ground (negative) cable.