Century V6-3100 3.1L VIN M SFI (1998)
Exhaust Manifold: Service and Repair
Exhaust Manifold Replacement (Right)
REMOVAL PROCEDURE
1. Disconnect the battery ground (negative) cable.
2. Remove the throttle body air inlet duct.
3. Remove the exhaust crossover pipe heat shield.
4. Remove the exhaust crossover pipe bolts to the right (rear) exhaust manifold.
5. Disconnect the heated oxygen sensor (H02S) wiring harness connector.
6. Raise and suitably support the vehicle.
7. Disconnect the three-way catalytic converter pipe from the right (rear) exhaust manifold.
8. Remove the Exhaust Gas Recirculation (EGR) tube from the rear exhaust manifold.
9. Remove the right (rear) exhaust manifold upper heat shield bolts.
10. Remove the right (rear) exhaust manifold upper heat shield.
