Century V6-3100 3.1L VIN M SFI (1998)
Alignment: Service and Repair
Front Toe Adjustment
1. Perform the following steps to remove the small seal clamp:
1.1. Position the steering wheel set in the straight ahead position.
1.2. Loosen the hex nuts on the tie rod in order to obtain the proper toe angle. Refer to WHEEL ALIGNMENT SPECIFICATIONS (FRONT
END).
2. Confirm the number of threads showing on each tie rod end is nearly equal.
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that
application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
3. Confirm that the tie rod ends are square before you tighten the lock nuts.
Tighten
Tighten the hex nuts at the tie rod ends to 68 Nm (50 ft. lbs.).
Important: Ensure the seals do not twist.
4. Install the seal clamps.
