Century V6-3100 3.1L VIN M SFI (1998)
11.
Tighten the pressure line fitting at pump to 27 N.m (20 lb ft).
12.
Carefully position the new pressure hose, forming a hose loop (1) as shown. Following this routing should result in an exhaust manifold heat shield
to hose clearance of at least 43 mm (1.75 in).
Notice:
The power steering pressure hose to the exhaust manifold clearance must be at least 43 mm (1.75 in) minimum or damage to the new power steering
hose will result. If clearance is insufficient, the hose routing or the part number is incorrect. Be sure to follow the illustrated routing to avoid a
build-up of torque in the P/S pressure hose assembly.
13.
Loosely attach the pressure pipe to the steering gear inlet.
14.
Install the pressure pipe to the steering gear housing clip.
15.
Tighten the pressure pipe fitting at the steering gear to 27 N.m (20 lb ft).
16.
Attach the shortened hose to the return pipe and secure with a spring clamp.
17.
Inspect installation and verify clearance between the pressure hose and the exhaust manifold, bulkhead, and other adjacent components. If
necessary, loosen the fittings, reposition the hoses and tighten the fittings to the torque values outlined above.
18.
Fill the power steering reservoir with new power steering fluid. Bleed the system. Refer to the Bleeding Power Steering System in the Power
Steering sub-section of the 1999 W Car Service Manual.
19.
Visually check all the fittings for leaks.
