Century V6-3100 3.1L VIN M SFI (1998)
Case: Service and Repair
4T65-E Automatic Transaxle
REPAIR PROCEDURE
1. Use solvent to clean the leak area.
2. Use compressed air to dry the area.
3. Follow the manufacturer's recommendations to mix a sufficient amount of GM P/N 1052533, or equivalent, epoxy cement.
CAUTION: Epoxy adhesive may cause skin irritations and eye damage. Read and follow all information on the container label as
provided by the manufacturer.
4. Use a clean and dry soldering acid brush to apply the epoxy cement while the transaxle case is hot.
5. Allow the epoxy cement to cure for three hours.
6. Start the engine.
7. Repeat the fluid leak diagnosis procedures.